Used Forklift Parts - In the long run, forklift components would wear and should be replaced. Purchasing brand new parts can become a costly undertaking so another idea is to purchase used lift truck parts. This can save much cash in the end. It is a good idea to acquire used forklift parts that have been reproduced. These components will guarantee that you are getting components that would work for a long time and be productive.
Broken or worn parts which are remanufactured are a very cost effective solution than rebuilding. With rebuilding components, just the parts that are worn out or broken get changed, which means that other wearable components could break down soon after purchase.
Remanufacturing however offers the best guarantee for used components. Remanufactured components are taken apart and cleaned and then all wearable pieces are changed. All wearable components are replaced regardless of age or wear which is another rationale why reproduced components on the whole function so much better. Whichever component within the part is brand new and this offers far longer life to the used part. Depending on the lift truck components which are being redone, the cleaning process and the whole remanufacturing process will vary.
The engines are cleaned after a complete disassembly. Several engine components like for instance rings, pistons, spark plugs, valves, valve springs, and filters can be replaced during the process of remanufacturing. The engines are hot tested after reassembly to guarantee that there are no oil pressure problems, no leaks, noises or any vacuum.
Transmissions are pressure washed, disassembled and oven cleaned. A complete inspection is performed in order to check for any cracks. Bushings, seals and bearings are all replaced. Normally, the replacement parts utilized on transmission components meet OEM specifications.
A few lift truck components like the alternator, the water pump, torque converters, the starter and steer axles could be quite serviceable after worn parts are replaced. The electronic control in the electric forklift is maintained by the control card. This particular card can even be reproduced with replacing all aged and worn out parts. Not like other forklift components the control card could only have the worn and aged components replaced.
Components which are reproduced have to be thoroughly checked upon reassembly to guarantee they are in good condition prior to being sold. When acquiring these components, it is a good idea to be sure that they have undergone all of the proper testing and inspections. On certain bigger components like engines, transmissions and steer axles, OEM specification replacement parts should be used.
The forklift dealer could guarantee that the components they have remanufactured meet the OEM specifications. This would even guarantee the components meet industry standards. Lots of details go into remanufacturing used components. This attention to detail offers more serviceability out of reproduced components compared to the parts that were only rebuilt.
Click to Download the pdf